The Service Life And Good Performance Of The Drill Pipe Of The Anchor Drilling Rig

The service life and good performance of the drill pipe of the anchor drilling rig

Nowadays, the application fields of anchor drilling RIGS are becoming increasingly common. Anchor drilling rig equipment is widely used in water conservancy, highway, hydropower equipment and railway projects, etc. Anchor drilling RIGS are also effectively used in the construction of deep foundation pit support in cities and base reinforcement engineering holes.

The anchor drilling rig has very good performance when in use. The structure of the entire equipment is relatively compact and small in size. When in use, the equipment is highly mobile and flexible, and can be well applied to carry out tasks on high slopes and scaffolding. The input torque of the hydraulic power head in the equipment is large, and the drilling capacity can play a better role.

The input speed of the power head of the anchor drilling rig is steplessly variable. During the operation process, its drilling parameters can be independently selected according to different construction requirements and geological conditions, thus effectively achieving the best drilling efficiency.

No matter what type of anchor drilling rig it is, the hydraulic transmission system of the equipment is a very important component. If it is not properly maintained during the operation process, various problems will occur, which will seriously affect the normal operation of the equipment.

During the operation of the anchor drilling rig, attention should be paid to the protection of the hydraulic system. The faults that can occur in the hydraulic system of the equipment are also diverse. The local faults that occur during the operation are caused by improper selection of oil, oil purification, air entry into the system and excessively high oil temperature.

When using the anchor drill pipe for the first drilling, it is necessary to "grind the new thread" first. This includes applying thread oil first, then fully tightening with the drill rig, opening the thread, applying thread oil again and opening it once more. Repeat this process three times to prevent new wear and jamming. Each time you fasten it, you must use full torque to tighten it and always pay attention to whether the shape of the clamping piece is good. When fastening, it should be tightened gradually to increase overheating wear.