The Types Of Drill Bits Used On Anchor Drilling RIGS

Apr 20, 2026

The types of drill bits used in anchor drilling RIGS are well-known in anchor drilling. The wide adaptability of the equipment is mainly due to its ability to be used in conjunction with various drill bits to meet the drilling requirements of different strata. The following is a detailed introduction to the types of drill bits used on anchor drilling RIGS.

 

1. To meet the drilling requirements of medium-soft and hard rock layers and achieve excellent drilling performance, a 27-millimeter diameter three-flush hole centrifugal double-wing drill bit with a three-degree negative Angle is used in conjunction with the anchor drilling rig. Due to the three flush holes designed on the drill bit, it can ensure that debris is quickly flushed away from the drill bit.

 

2. Another type that is relatively similar is an alloy drill bit with a diameter of 27 millimeters and a three-degree negative Angle. The alloy material enables the drill bit to be easily applied in medium-hardness rock layers. It not only has a fast drilling efficiency but also has a long service life itself.

 

3. Some belong to hard rock strata, which requires the drill bit used for drilling to have outstanding wear resistance and impact resistance. The 27-millimeter diameter neutral Angle, central flushing hole, and improved straight-line drill bit precisely meet the requirements. A deformed alloy sheet is set above the scouring water hole at the center of the drill bit. This special design can prevent the water hole from being blocked and affecting the drilling operation.